Honeywell Bonterra User Manual page 7

FINAL INSTALLATION
4. Partially insert three blade screws, along with the blade washers, through the blade and into the blade arm. Tighten each
blade screw, starting with the one in the middle. Repeat this step for the remaining blades and blade arms (Figure 5.4).
5. Remove the ten motor screws from the motor assembly. Then install the blade arms into the underside of the motor assembly
using the motor screws. Completely secure each blade arm to motor assembly before moving to the next (Figure 5.5).
6. Remove one fitter plate screw from the fitter plate and loosen, but do not remove the other three. Insert the 9-pin connector
from the motor assembly through the hole in the light pan. Align the three key slots in the light pan with the loosened fitter
plate screws. Place the light pan over the three screws and turn the light pan clockwise. Re-install the previously removed
light pan screw, and tighten all four screws securely (Figure 5.6).
7.Remove one of the light pan screws from the light pan, and loosen (do not remove) the other two screws. Then, connect the
9-pin connector from the fan to the 9-pin connector from the light kit. Then, lift the two key hole slots in the light kit over the
loosened light pan screws. Turn the light kit in a clockwise direction and reinstall the previously removed light pan screw.
Tighten all three screws securely (Figure 5.7).
8. Install the E26-base B10 bulbs in the sockets of the light kit (Figure 5.8).
9. Align the grooves on the glass bowl with the raised bumps on the light kit. Then, turn the glass bowl in a clockwise direction
until the glass is secure (Figure 5.9).
Blade Screw
Blade Washer
Blade Arm
Figure 5.4
Light Kit Screw
Figure 5.7
Blade
Motor Screw
Figure 5.5
Bulb
Figure 5.8
Blade Arm
Figure 5.6
Raised Bump
Figure 5.9
7
9-pin
Connector
Light
Pan
Fitter
Plate
Screw
Groove
Glass Bowl