Correct Use; Applicable Standards; Iec Standards - Omron V700 Series Operation Manual

EN/IEC Standards
5

Correct Use

!
!
!
6

Applicable Standards

7 EN/IEC Standards
AUDIN - 7 bis rue de Tinqueux - 51100 Reims - France - Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : info@audin.fr
• Be sure that all the mounting screws, terminal screws, and cable connector
screws are tightened to the torque specified in the relevant manuals.
• Use crimp terminals of specified size for wiring.
• Be sure that the items with locking devices are properly locked into place be-
fore using the System.
• Be sure that the DC Power Supply Unit exclusively designed for the V700 Se-
ries is used and is not connected to any other device.
• Be sure that the power supply voltage is within the rated range of 24 VDC+10%
and –15%.
• Do not remove the ferrite cores attached to the V700-H01 and V700-H02.
• Install the ferrite core supplied with the V700-CD1D-V3 or V700-CD2D-V3 ac-
cording to the specified instructions.
• Be sure to observe all warnings, cautions, and safety precautions specified in
the manual.
Caution Do not install the V700-H01, V700-H02, V700-CD1D-V3, or V700-CD2D-V3 in
the following locations:
• Locations subject to direct sunlight.
• Locations subject to condensation as the result of severe changes in tempera-
ture.
• Locations subject to corrosive or flammable gases.
• Locations subject to shock or vibration.
Caution Be sure to observe the following wiring precautions:
• Do not wire the lines of the RFID System alongside high-tension or power
lines.
• Check the polarity of each terminal and make sure not to make mistakes in po-
larity.
Caution Be sure to observe the following precaution when cleaning the V700-H01,
V700-H02, V700-CD1D-V3, or V700-CD2D-V3:
• Organic solvents may damage the paint coating on the casing or resin part of
the product. Do not use paint thinner or any other organic solvent to clean the
product.
The V700-series Electromagnetic Inductive RFID System conforms to the fol-
lowing standards:
• EC Directives EN50081-2
• EC Directives EN50082
• In connection with EC unification, eighteen European countries will integrate
their conventional safety standards into EN standards. When the EN stan-
dards come into effect, they will apply as the unified European standards in
place of the conventional safety standards.
• EN standards are based on IEC standards. Therefore, machines that are ex-
ported to Europe from Asia or North America must satisfy EN standards.
Otherwise, the machines must satisfy IEC standards if the machines do not fall
under EN standards.
7
xiii