Table of Contents
Advertisement
EN/IEC Standards
5
Correct Use
Caution
!
Caution
!
Caution
!
6
Applicable Standards
7
EN/IEC Standards
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Be sure that all the mounting screws, terminal screws, and cable connector
screws are tightened to the torque specified in the relevant manuals.
Be sure that the items with locking devices are properly locked into place be-
fore using the System.
Do not remove the ferrite core attached to the V720-H01-E.
Be sure to observe all warnings, cautions, and safety precautions specified in
the manual.
Do not install the V720-H01-E in the following locations:
Locations subject to direct sunlight.
Locations subject to condensation as the result of severe changes in tempera-
ture.
Locations subject to corrosive or flammable gases.
Locations subject to shock or vibration.
The RFID System operates at a frequency of 13.56 MHz to communicate with
the Tags. Be sure to observe the following precautions to minimize the electrical
noise that may be caused when the RFID System is placed near transceivers,
motors, monitoring devices, or power supplies. Also confirm that the System is
not affected by such noise in advance.
Connect surrounding metallic devices to a ground of 100 Ω or less.
Do not wire the lines of the RFID System alongside high-tension or power
lines.
Check the polarity of each terminal and make sure not to make mistakes in po-
larity.
Be sure to observe the following precaution when cleaning the V720-H01-E:
Organic solvents may damage the paint coating on the casing or resin part of
the product. Do not use paint thinner or any other organic solvent to clean the
product.
The V720-H01-E conforms to the following standards:
European Standard
EN 300 330 (1999)
ETS 300 683 (1997)
EN 60065
FCC (USA)
FCC Part 15 Subpart C
CCA (Canada)
CCA 210 Category I Equipment
ARIB (Japan)
ARIB STD-T60
In connection with EC unification, eighteen European countries will integrate
their conventional safety standards into EN standards. When the EN stan-
7
xiii
Advertisement
Table of Contents
