Installation Of Antenna; Installation Environment - Omron V700 Series Operation Manual

Installation of Antenna

4-2

Installation of Antenna

4-2-1 Installation Environment

Installation Location
Countermeasures Against Noise
Power Lines and
High-tension Lines
Inverters, Motors, and
Other Driving
Mechanisms
Displays of Personal
Computers and
Programmable Terminals
AUDIN - 7 bis rue de Tinqueux - 51100 Reims - France - Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : info@audin.fr
56
3. Install the connector in the Controller. Align the cable's connector with the
Controller's connector and insert the cable's connector fully into the Control-
ler. Tighten the retaining screws to a proper torque (about 0.3 N@m).
4. To remove the connector, completely loosen the two retaining screws and
pull the connector straight out of the Controller. If the connector is difficult to
remove, push against the Controller while pulling out the connector.
Note Do not connect wires in the connector while it is installed in the Controller.
Do not install the Antenna in the following locations.
• The ambient temperature is not within a range between –20°C and 55°C or
locations with radical temperature changes resulting in condensation.
• The humidity is not within a range between 35% and 80%.
• There is corrosive gas, flammable gas, dust, salt, or metal powder.
• The Antenna will be subjected to direct vibration or shock.
• Water, oil, or chemical will be sprayed onto the Antenna.
The communications range of the Antenna drops due to ambient noise. Refer to
9-1 Communications Distance Characteristics vs. Ambient Noise for details.
The following provides information on countermeasures against ambient noise.
Do not wire the Antenna cable along with high-tension lines or power lines. Keep
the Antenna cable as far away as possible from them.
Be sure to ground the frames of driving mechanisms and keep them as far away
as possible from the Antenna.
Keep the displays of personal computers and Programmable Terminals as far
away as possible from the Antenna.
Section
Retaining screws
4-2