Table of Contents
Advertisement
Sterilized water*
The function of sterilized water is to disinfect the wand.
After customer uses front wash, rear wash or spiral wash function, the toilet will activate sterilized water
function after customer leaves toilet.
When the toilet is out of use, sterilization will be activated once every 8 hours.
* Sterilized water (refers to refers to the tap water containing hypochlorite generated by chlorine ions after ionization): Sterilized water generated during electrolysis working cycle eliminates
bacteria on the nozzle surface. The antibacterial rate is more than 96%. (Perform test in accordance with GB /T 23131 when the content of chlorine ions in tap water is >24ppm. Different
water quality might cause different sterilization effect. Electrolysis working cycle activation method refers to operation description. Testing lab: China household electrical appliances testing
institute.).
Automatic energy saving function
When energy saving set to ON status, product shall auto detect the idle hours and decrease the
heating temperature to reach of energy saving purpose.
For details of automatic energy saving, refer to pages 9.
Deodorizer
Product default factory setting is auto activate deodorizer function when detecting customer seated.
Refer to Remote Setting for how to switch over auto deodorization function.
Maintenance and cleaning
A. Normal cleaning
For the best effect, remember the following rules during maintenance of your Kohler product:
Important! Do not flush the cover directly by water (including remote controller)
FiTesting - apply cleaning solution at an inconspicuous place on lid for testing. Make sure the cleaning
solution will not damage the outer surface of cover, and then apply it to the entire surface.
Do not immerse in cleaning solution. Do not immerse the product in cleaning solution.
Avoid using materials that will damage the surface-Clean the surface with a soft and wet sponge or cotton
cloth, instead of materials that can damage the surface.
Scrubbing - After adding the cleaner, use a wet towel to scrub the surface immediately to remove cleaner
or dirt sprayed to the surface.
Cleaning the seat
Do not use abrasive cleanser or sanitizer inside the spray tank for cleaning.
Maintenance: In case of using a mixture of washing agent and
water as well as any available solution for seat cleaning, use
soft and wet sponge or towel to clean the seat. Use a soft towel
to make the seat dry, or let it dry naturally.
Corrosive chemicals or cosmetics (such as nail polish or aftershave) should not come in contact with the
seat as this will damage the surface.
Clean stainless steel beauty parts
Clean surface with neutral soap water, and then wipe the whole surface off with clean
and soft rag. Do not use cleaners, such as Ammonia, decontamination powder or toilet
cleaner which will cause surface damage.
Caution: Failure to follow cleaning instructions may invalidate the warranty of Kohler.
Caution: The success of the cleaning process depends on the water hardness and
temperature, the dose precision of composition, cleaning regulation variation and cleaning
product status etc. factors. Kohler can't ensure the validity of rules since these factors
may change.
Caution: When clean the opening lid, brute force applied to the lid will damage the product.
Clean hinge arm
Wipe the hinge arm by a soft cloth on a regular basis to prevent from sticking to the
hinge arm, and to reduce the brightness of the hinge.
1413476-TW01-A
16
Kohler Co.
Advertisement
Chapters
Table of Contents
