Miele ProLine CS 1018 G Operating And Installation Instructions page 56

Converting to another gas type
Changing the outer burner main jet
 Use an open spanner (SW 10) to
rotate the main jet anti-clockwise out
of the jet holder. Use another open
spanner (SW 13) for support while
you are doing this (see illustration).
 Fit the new jet (see jet table) and
rotate it into place, using the open
spanner for support again.
 Secure the jets against inadvertent
loosening with sealing wax.
56
Checking the first intake of air
a Adjustment screw
b Air intake sleeve
Gap X must measure:
For Natural gas: 6 mm
For Liquefied Petroleum gas: 13 mm
For Town gas: 13 mm
To set gap X
 Loosen screw  and slide the air
intake sleeve .
 Then retighten the screw.