Connecting the battery to the charger
Connect the battery charger positive (11a) and
negative (9a) leads to the battery terminals: the red
one (11) to the positive terminal (+), the black one (9)
to the negative terminal (-).
Connect the plug of the battery charger to the wall
outlet.
Charge battery using the special Ducati-approved
battery charger (A) for lithium batteries, only.
Do not use battery chargers for lead batteries or any
other type of battery maintainer/charger.
Charge the battery ensuring the vehicle is in a room
with a temperature below 40° C (104° F).
Attention
Keep the battery out of the reach of children.
Attention
Use only the Ducati-approved battery charger
(A) for lithium batteries also as a maintainer.
Do not use the battery charge maintainer kit part no.
69924601A (various countries) or battery charge
maintainer kit no. 69924601AX (for Japan, China and
Australia only), as it is specific for lead batteries.
244
A
11a
Attention
NEVER connect the battery in parallel with
that of other vehicles, as this may cause a short
circuit or overheating of the battery.
To maintain the battery charge and use the Ducati-
approved battery charger, proceed as described in
the chapter "Maintaining the battery charge".
When charging is complete, disconnect the battery
charger power cable from the wall outlet, remove the
black clip (9a) from the negative pole (-) and the red
clip (11a) from the positive pole (+).
9a
Fig 189