Changing the Pin Code
Enter the Setting menu.
●
Use buttons (1) and (2) to select item "Pin Code"
●
and press the ENTER button (3).
Select the "Modify Pin" item and press the
●
ENTER button (3).
The display shows the message "Old Pin" and the
spaces to enter the four digits of the old pin
(Fig 132). The two arrows above and below the first
digit give the possibility to set it. Entering the code:
Use buttons (1) and (2) to increase and decrease
●
by 1 the value from "0" to "9".
Press the ENTER button (3) to confirm the digit
●
and move on to the following digit.
Repeat the procedure until entering all 4 digits.
●
Once the fourth digit is set, press ENTER (3) and the
instrument panel behaviour will be as follows:
if the pin code is not correct, the instrument
●
panel displays "Wrong" highlighted in red for 2
seconds and then goes back to previous screen,
to allow you to try again;
if the pin code is correct, the instrument panel
●
shows "Correct" highlighted in green for 2
seconds, and then displays the page for entering
194
Back
Modify Pin
...
Old Pin
0 - - -
...
Fig 131
Fig 132