Instrument and control functions
To use the power outlet
1. Turn the vehicle power off.
2. Open the storage compartment A.
(See page 5-18.)
3. Remove the power outlet cap.
4. Turn the accessory off.
5. Insert the accessory plug into the
power outlet.
6. Turn the vehicle power on and
start the engine.
5
7. Turn the accessory on.
TIP
When finished riding, turn off the ac-
cessory and disconnect it from the
power outlet, and then install the cap.
1
1. Power outlet cap
WARNING
To prevent electrical shock or short-
circuiting, install the cap when the
power outlet is not in use.
5-24
EWAN0050
Sidestand
The sidestand is located on the left
side of the frame. Raise the sidestand
or lower it with your foot while holding
the vehicle upright.
TIP
The built-in sidestand switch is part of
the ignition circuit cut-off system,
which cuts the ignition in certain situa-
tions. (See the following section for an
explanation of the ignition circuit cut-
off system.)
WARNING
The vehicle must not be ridden with
the sidestand down, or if the side-
stand cannot be properly moved up
(or does not stay up), otherwise the
sidestand could contact the ground
and distract the operator, resulting
in a possible loss of control.
Yamaha's ignition circuit cut-off
system has been designed to assist
the operator in fulfilling the respon-
sibility of raising the sidestand be-
fore starting off. Therefore, check
EAU15306
EWA10242