Omron SYSMAC-SE2 Series Practices Manual page 49

ID
20253 1 CPU: Name [1]
I/O Interface Unit CJ1W-II101
 PLC Box
Set the PLC box setting values as follows.
ID
20161 Configuration project
20408 Station ID
20427 Rack ID
20410 PLC card is placed on rack ID
20411 Position (slot / module)
20253 1 CPU: Name [1]
Precautions for Correct Use
To import a CJ-series Unit configuration, you need to set this as follows.
• Set rack numbers so that they are sequential numbers that start from 1.
• Set not more than three CJ1W-II101 Units for one CPU Unit.
CJ-series Units in an Expansion Rack Configuration (Excluding I/O
Interface Units)
 PLC Box
Set the PLC box setting values as follows.
ID
20161 Configuration project
20408 Station ID
20427 Rack ID
20410 PLC card is placed on rack ID
20411 Position (slot / module)
20253 1 CPU: Name [1]
20418 Version
Sysmac Studio Electrical CAD Connector Function Practices Guide for AutomationML Import (EPLAN Electric P8) (P156)
Property name
Property name
Property name
Same value as "Configuration project" of the CPU Unit
Same value as "Station ID" of the CPU Unit
Blank
Same value as "Rack ID" of the CJ1W-II101 to which the CJ-
series Unit belongs
Slot number
Same value as "CPU: Name [1]" of the CPU Unit
Version (This must be a version that exists in the Sysmac Stu-
dio and a single-byte number that contains periods as the de-
limiter. To specify the version of a Unit whose version is indicat-
ed as "---" on the Sysmac Studio, set "---" or "0.0".)
If blank, the component data will be imported with the latest
version.
3 Setting EPLAN Electric P8
Setting value
Blank
Setting value
Same value as "Configuration project" of the CPU
Unit
Same value as "Station ID" of the CPU Unit
Rack number
Blank
Blank
Same value as "CPU: Name [1]" of the CPU Unit
Setting value
3
3-13