Product Safety Labels - Barco F400 Safety Manual

Safety Information
• Attempts to alter the factory-set internal controls or to change other control settings not specially discussed
in this manual can lead to permanent damage to the projector and cancellation of the warranty.
• Unplug this product from the wall outlet and refer servicing to Barco authorized service personnel or
technicians under the following conditions:
- If liquid has been spilled into the equipment.
- If the product has been exposed to rain or water.
- If the product does not operate normally when the operating instructions are followed. Adjust only those
controls that are covered by the operating instructions since improper adjustment of the other controls
may result in damage and will often require extensive work by a qualified technician to restore the
product to normal operation.
- If the product has been dropped or the cabinet has been damaged.
- If the product exhibits a distinct change in performance, indicating a need for service.
- When the power cord or plug is damaged or frayed.
• Replacement parts: When replacement parts are required, be sure the service technician has used original
Barco replacement parts. Unauthorized substitutions may result in degraded performance and reliability,
fire, electric shock or other hazards. Unauthorized substitutions may void warranty.
• Safety check: Upon completion of any service or repairs to this projector, ask the service technician to
perform safety checks to determine that the product is in proper operating condition.
Safety data sheets for hazardous chemicals
For safe handling information on chemical products, consult the Safety Data Sheet (SDS). SDSs are available
upon request via safetydatasheets@barco.com.

1.3 Product safety labels

Light beam related safety labels
Label image Label description
Hazard RG3: optical radiation warning symbol
THIS PRODUCT IS IN CONFORMITY WITH PERFORMANCE
STANDARDS FOR LASER PRODUCTS UNDER 21 CFR 1040,
EXCEPT WITH RESPECT TO THOSE CHARACTERISTICS
AUTHORIZED BY VARIANCE NUMBER 2016-V-0144
EFFECTIVE ON DECEMBER 12, 2019.
Ce projecteur peut devenir RG3 si aucun objectif ou un objectif interchangeable
avec un rapport de projection supérieur à 2.4 n'est installé. Veuillez vous reporter au
manuel pour en savoir plus sur la liste des objectifs et la distance de sécurité avant
toute utilisation. De telles combinaisons entre projecteur et objectif sont conçues
pour des applications professionnelles uniquement et pas pour des applications
grand public.
This projector may become RG3 when no lens or an interchangeable lens with
throw ratio greater than 2.4 is installed. Refer to the manual for the lens list and
hazard distance before operation. Such combinations of projector and lens are
intended for professional use only, and are not intended for consumer use.
当未安装任何镜头，或者安装投射比大于2.4的可互换镜头时，本投影机可能会列为
风险组3(RG3)。 操作前，请先参考手册中的镜头清单和危险距离。本投影机和镜头
组合仅供专业人员使用，非普通消费者使用
若本投影機未安裝任何鏡頭或者安裝投射比大於2.4的可交換鏡頭時，可能歸類為風
險組3(RG3)。 操作前，請先參考手冊中有關鏡頭清單與危險距離的資訊。上述投影
機與鏡頭組合僅供專業用途，不適合一般消費者使用。
8 R5914422 /00 F400
Label location