Stihl MH 600 Instruction Manual page 33

6 Assembling the Cultivator
6.3 Attaching the Front Wheel
► Slide front wheel (1) onto frame (2) so the
bores align.
► Insert bolt (3) into the rear bore.
► Place washer (4) on bolt (3).
► Screw on nut (5) and tighten.
► Insert pin (6) through the front bore.
► Push retaining pin (7) through the bore in
pin (6).
Pin (6) is secured and front wheel (1) is locked
in position.
The front wheel must not be dismantled again.
6.4 Attaching the Handlebar
► Fit lower handlebar (1) onto mount (2) and
align locating lug (3) with centre position (4).
► Screw in screw (5).
Lower handlebar (1) is locked in place.
0478-404-9807-B
► Push anti-dust protection (6) downwards so
that locating lug is covered.
► Press lever (7) downwards and hold.
► Insert upper handlebar (8) through lower han‐
dlebar (1) from below using bolts (9).
► Release lever (7) and allow upper handle‐
bar (8) to engage at centre detent (10).
► Attach upper handlebar (8) with washers (11)
and nuts (12).
► Tighten nuts (12) to 20 Nm to 25 Nm.
Upper handlebar (8) is locked in place.
The handlebar must not be dismantled again.
► Fasten the cables to the handlebar at regular
intervals using cable ties (13).
► Secure cables (14) by bending the cable
clip (15) on the tiller.
English
33