Kyocera MA2001w Operation Manual page 142

Symptom
Vapor is emitted near the
inner tray.
Printing speed has
slowed down.
Blank sheets are
ejected.
Paper often jams.
2 or more sheets are
overlaps when ejected.
(multi feed)
Printouts are wrinkled.
Checkpoints
Check if the temperature is low near
the location of the machine, or if the
paper that is being used has been
exposed to humidity.
Did you unplug the power cord?
Are the originals loaded correctly?
Is the paper loaded correctly?
Is the paper of the supported type? Is
it in good condition?
Is the paper curled, folded or wrinkled? Replace the paper with new paper.
Are there any loose scraps or jammed
paper in the machine?
—
—
Is the paper damp?
Corrective Actions
Depending on the operating
environment of the machine and the
condition of the paper, heat generated
during printing can evaporate water
moisture in the printed paper, emitting
vapor from the machine. In this case,
printing can be continued without any
problem.
To correct this, increase the
temperature in the room, and use
paper that has been stored in a dry
place.
It will return to normal printing speed in
about 15 minutes.
When placing originals on the platen,
place them face-down and align them
with the original size indicator plates.
Load the paper correctly.
Remove the paper, turn it over, and
reload it.
Remove any jammed paper.
Clean the Paper feed roller.
Load the paper correctly.
Replace the paper with new paper.
9-2
Troubleshooting
Reference
Page
—
—
3-12
3-8, 3-9
3-3
3-3
9-9
9-16
3-8
3-3