Stihl HTA 66 Instruction Manual page 49

20 Specifications
HTA 86
Permitted batteries:
– STIHL AP
– STIHL AR
– Weight without battery: 4.6 kg
– Max. oil tank capacity: 105 cc (0.105 l)
– Degree of electrical protection: IPX4 (protec‐
tion against splash water from any direction)
For runtime, see www.stihl.com/battery-life.
20.2 Chain Sprockets
The following chain sprockets may be used:
– 6-tooth for 1/4" P
20.3 Minimum groove depth of guide
bars
The mininum groove depth depends on the pitch
of the guide bar.
– 1/4" P 4 mm
20.4 STIHL AP battery
– Battery technology: lithium-ion
– Voltage: 36 V
– Capacity in Ah: see rating label
– Energy content in Wh: see rating label
– Weight in kg: see rating label
– Permissible temperature range for operation
and storage: + 10 °C to + 50 °C
®
– Bluetooth radio interface (only for batteries
with ):
– Data connection: Bluetooth
mobile appliance must be compatible with
®
Bluetooth Low Energy 5.0 and support
Generic Access Profile (GAP).
– Frequency band: ISM band 2.4 GHz
– Maximum RF power transmitted: 1 mW
– Signal range: approx. 10 m. The signal
strength depends on the ambient conditions
and the mobile terminal. Signal range can
vary greatly depending on local conditions,
including the receiver. The range may be
perceptibly reduced inside enclosed rooms
and through metal barriers (such as walls,
shelves or cases).
– Mobile appliance operating system require‐
ments: Android or iOS (current version or
higher)
20.5 Sound Values and Vibration
Values
K-value (uncertainty) for sound pressure levels is
2 dB(A). K-value for sound power levels is 2
dB(A). The K-value for vibration levels is 2 m/s².
0458-191-9821-B
®
5.1. The
HTA 66
STIHL recommends wearing ear defenders.
– Sound pressure level L
to ISO 22868: 78 dB(A)
– Sound power level L
ISO 22868: 93 dB(A)
– Vibration level a measured according to
hv
ISO 22867
– Control handle: 1.0 m/s²
– Handle hose: 1.0 m/s²
HTA 86
STIHL recommends wearing ear defenders.
– Sound pressure level L
to ISO 22868: 77 dB(A)
– Sound power level L
ISO 22868: 93 dB(A)
Shaft fully compressed:
– Vibration level a measured according to
hv
ISO 22867
– Control handle: 1.0 m/s²
– Handle hose: 1.0 m/s²
Shaft fully extended:
– Vibration level a measured according to
hv
ISO 22867
– Control handle: 1.0 m/s²
– Handle hose: 1.0 m/s²
The vibration levels indicated were measured
according to a standardized test method and can
be used as a basis for comparing electric power
tools. The vibration levels actually occurring may
vary from the values indicated, depending on the
type of application. The vibration levels indicated
can be used for an initial estimate of the vibration
stress. The actual vibration stress has to be esti‐
mated. The times when the power tool is
switched off and the times when it is switched on
but running under no load can be taken into
account in the estimate.
For information on compliance with Employers'
Vibration Directive 2002/44/EC see
www.stihl.com/vib.
20.6 REACH
REACH is an EC regulation and stands for the
Registration, Evaluation, Authorisation and
Restriction of Chemical substances.
For information on compliance with the REACH
regulation see www.stihl.com/reach.
English
measured according
pA
measured according to
wA
measured according
pA
measured according to
wA
49