Pioneer AVIC-Z1000DAB Operation Manual page 123

Menu Item
[Automatic Level Control]
[Off]
[Mode1]
[Mode2]
[Sound Retriever]
[Off] [Mode1] [Mode2]
*1 [All] is not available when [Network Mode] is selected as the speaker mode.
*2 If you change the listening position setting, the output levels of all the speakers will change in
conjunction with the setting.
*3 To use this function, the vehicle's acoustics must be measured in advance.
*4 This function is available only when the [Listening Position] setting is set to [Front Left] or [Front
Right].
Adjusting the cutoff frequency value
You can adjust the cutoff frequency value of each speaker.
The following speakers can be adjusted:
[Standard Mode]: Front, Rear, Subwoofer.
[Network Mode]: High, Mid, Subwoofer.
NOTES
• Subwoofer settings are available only when [Subwoofer] is [On].
• Rear speaker settings are available only when [Rear Speaker Output] is [Rear].
1
Touch .
2
Touch then
3
Touch [Crossover] or [Subwoofer Settings].
4
Touch or
5
Drag the graph line to set the cutoff position.
6
Drag the lowest point of the graph to set the cutoff slope.
The following items can also be set.
Description
Corrects automatically the audio level difference between
the music files or the sources.
Turns the auto level control setting off.
Corrects a little the audio level difference between the
music files or the sources (for the narrow dynamic range
audio signal).
Corrects widely the audio level difference between the
music files or the sources (for the wide dynamic range
audio signal).
Enhances compressed audio and restores rich sound
automatically.
TIP
[Mode2] has a stronger effect than [Mode1].
.
to switch the speaker.
- 123 -