Adjustments (Normal Mode) - Sony GDM-90W01T Operating Instructions Manual

Adjustments (Normal mode)

You can adjust the picture to your preference.
This monitor has two levels of adjustment mode, normal
and expert.
Before adjusting
• Connect the monitor and the computer, turn them on and
feed the signal to the monitor.
• Select "LANGUAGE" in the "OPTION" OSD, then select
"ENG" (English) on page 7.
Selecting the normal mode
1
Press the button.
The "OPTION" OSD appears.
2
Press the ¨./> button to select "OSD MENU."
The "OSD MENU" becomes yellow.
3
Press the >?// button to select "NORMAL."
Move the green p to "NORMAL".
The "OPTION" OSD automatically disappears after about
30 seconds. To turn off the OSD, press the
8
OPT I ON
L ANGUAGE JPN ENG FRA
DEU ESP I TA
OSD POS I T I ON : R I GHT BOTTOM
OSD MENU NORMAL EXPERT
LOCK UNLOCK LOCK
I NPUT : 1 84.4kHz/ 72Hz
SELECT SET
OPT I ON
L ANGUAGE JPN ENG FRA
DEU ESP I TA
OSD POS I T I ON : R I GHT BOTTOM
OSD MENU NORMAL EXPERT
LOCK UNLOCK LOCK
I NPUT : 1 84.4kHz/ 72Hz
SELECT SET
E004.OSD
OPT I ON
L ANGUAGE
JPN ENG FRA
DEU ESP I TA
OSD POS I T I ON : R I GHT BOTTOM
OSD MENU NORMAL EXPERT
UNLOCK LOCK
LOCK
I NPUT : 1 84.4kHz/ 72Hz
SELECT SET
button again.
Adjusting the picture
brightness
The adjustment data becomes the common setting for all
input signals received.
1
Press the¨ (brightness) ./> button.
The "BRIGHTNESS/CONTRAST" OSD appears.
2
Press the ¨./> button again to adjust picture
brightness.
. . . . for less brightness
> . . . for more brightness
The OSD automatically disappears after about 3 seconds.
To reset, press the ? (reset) button while the OSD is on.
The brightness and contrast are both reset.
Adjusting the picture contrast
The adjustment data becomes the common setting for all
input signals received.
1
Press the > (contrast) ?// button.
The "BRIGHTNESS/CONTRAST" OSD appears.
2
Press the >?// button again to adjust picture
contrast.
? . . . for less contrast
/ . . . for more contrast
The OSD automatically disappears after about 3 seconds.
To reset, press the ? (reset) button while the OSD is on.
The brightness and contrast are both reset.
BR I GHTNESS / CONTRAST
2 3 10
BR I GHTNESS / CONTRAST
2 3 10