Using Wps To Connect To A Network; Printing A Network Status Sheet - Epson SureColor P8570D Series User Manual

Using WPS to Connect to a Network

If you have a WPS-enabled wireless router or access point, you can use Wi-Fi Protected Setup (WPS) to
connect your product to the network.
Note: This setting can be locked by an administrator. If you cannot access or change this setting,
contact your administrator for assistance.
1. Select the
2. Select the
3. Select Router > Start Setup or Change Settings > Push Button Setup (WPS).
4. Follow the instructions on the LCD screen to complete WPS setup.
5. Select the
You see the
your computer or device, and then print. If you are printing from a computer, make sure you installed
the product software from the Epson website.
Note: If you don't see the
these steps to try again. If it still does not work, print a network connection report and check the
solution.
Parent topic:
Related tasks
Accessing the Web Config Utility

Printing a Network Status Sheet

You can print a network status sheet to help you determine the causes of any problems you may have
using your product on a network.
Before you begin, make sure paper is loaded in the product.
1. Select the
2. Select General Settings > Network Settings > Network Status.
home icon, if necessary.
icon.
home icon to exit.
icon on the LCD screen and should be able to connect to your product directly from
icon, restart the access point, move it closer to the printer, and repeat
Wi-Fi Protected Setup (WPS)
icon.
42