Advertisement
Technical Data (cont´d)
Terminal output Outputs
Cable lengths
Cross-sectional areas
Electrical connections of
actuators
Smart Infrastructure
Total contact output:
Rated voltage
Refer also Total contact output in chapter Terminal output Outputs
Individual contact loads:
Fuel valve
Rated voltage
Rated current
Power factor
Safety valve (magnetic clutch / oil pump)
Rated voltage
Rated current
Power factor
Connections for pressure switch
Rated voltage
Rated current
Power factor
Power supply for pressure switch -max / POC (X5-02 pin 3 or X22-02 pin 3)
IaMax
Fuel feedback to LMV36. .. (X31-02 pin 1 or X31-02 pin 2)
IaMax
Mains line LMV36 AGM60
Fuel valves
Other lines
Fuel selector
Load controller
Specification as per EN 60730-1:2016
Type of shutdown or interruption of each circuit
Shutdown with microswitch
Mode of operation
The cross-sectional areas of the power supply lines (L, N and PE) must be capable of
carrying the rated currents according to the built-in unit fuse of the respective LMV36
(max. 6.3 AT).
Cross-sectional area
Cable insulations must satisfy the relevant temperature requirements and
environmental conditions.
The fixed connected actuator cables must not be extended.
AC 120 V, 50/60 Hz
AC 120 V, 50/60 Hz
1.6 pilot duty output declaration to UL732
Cos >0.4
AC 120 V, 50/60 Hz
1.6 A pilot duty output declaration to
UL732
Cos >0.4
AC 120 V , 50/60 Hz
1.5 mA
---
<10 mA
<10 mA
Max. 3 m (100 pF/m)
Max. 3 m (100 pF/m)
Max. 3 m (100 pF/m)
Max. 20 m (100 pF/m)
Max. 20 m (100 pF/m)
Single-pole
Type 2 B
Min. 0.75 mm² (single- or multi-core to
VDE 0100)
27/30
CC1N7544en
21.05.2021
Advertisement
