Sunfire Theater Grand Processor III User Manual page 36

CHAPTER 4
Main Zone and Zone 2 Menu
MAIN MENU
TRIMS
MODES
TONE
INPUTS
SETTINGS
MAIN ZONE
ZONE 2
SPEAKERS
VIDEO
SOFTWARE
CONTROL
36
SETTINGS
MAIN ZONE
POWERUP SOURCE
POWERUP VOL MODE PRESET
POWERUP VOL
MAX VOL
ZONE 2
ZONE 2 SYSTEM
BALANCE
POWERUP SOURCE
POWERUP VOL MODE PRESET
POWERUP VOL
MAX VOL
Zone 2 Menu
These settings are like those de-
scribed for the Main Zone. In addition,
the entire Zone 2 can be enabled
or disabled, and the stereo balance
adjusted with this menu.
Zone 2 is set "disabled" from
the factory, so you should
use this menu to enable
Zone 2 when you are ready to use it.
The Power Up Volume has three
options: PRESET, LAST and FIXED.
The FIXED option allows you to set
the Zone 2 to a fi xed volume, not
adjustable with the remote. PRESET
and LAST are as described for the
Main Zone.
Main Zone Menu
PowerUp Source
DVD
-45dB
-6dB
Power Up Volume Mode
ENABLE
2 LEFT
TAPE
Power Up Volume
-45dB
-6dB
Max Volume
This sets the input source
which the TGIII will then always
select whenever the TGIII is
turned on.
This lets you choose the vol-
ume level the TGIII reaches
when it is turned on. You can
select from a PRESET level,
set below (the power-up vol-
ume), or it can play at the LAST
level it was playing before it
was turned off. The TGIII will
always turn on at the level set
here, but it can be adjusted to
any level afterwards.
This allows you to set the PRE-
SET volume level mentioned
above. You might want to set it
to a low level to avoid any sur-
prises upon turn-on, especially
if other users like loud music.
The volume can be set to not
exceed a certain level. This
is useful if you have sensitive
speakers, sensitive neighbors,
or you would rather not have
others play your system too
loud.
User's Manual