Table of Contents
Advertisement
Wear an ESD-preventive wrist strap, and make sure the wrist strap
Step1
makes good skin contact and is properly grounded.
Loosen the captive screws on the OAP card with the Philips screwdriver
Step2
until all spring pressure is released.
Hold each ejector lever with a hand and pull the ejector levers outward
Step3
(see callout 4 in
guide rails (see callout 3 in
Figure 7 Remove the OAP card
(1) OAP card
(3) Removal direction of the OAP card
WARNING!
The protection panel on the OAP card surface has a yellow warning label
, indicating that this area corresponds to the inner heat
radiator. After the OAP card runs for a period of time, this area may be
very hot. So keep your hands away from the area while removing the OAP
card to avoid being hurt.
Figure
7). Then pull out the OAP card slowly along the
Figure
9
7).
(2) Rear panel of the switch
(4) Unlocking direction of the ejector
levers
Advertisement
Table of Contents
