Table of Contents
Advertisement
Figure 3 Remove the blank panel
(1) Rotation direction of the Phillips screwdriver
(3) Phillips screwdriver
Take the OAP card out of the package. Then, you can select to insert
Step3
the OAP card as shown in
or reversely insert the OAP card as shown in
levers on top. Select a proper installation mode based on the hardware
structure of your switch.
NOTE:
The insertion and reverse insertion procedures are the same. This
document uses reverse insertion of an OAP card to an A5800-48G-PoE+
Switch with 2 Interface Slots (JC101A) as an example.
Figure 4 Insert an OAP card
(2) Blank panel of the OAP card
slot
Figure 4
with the ejector levels at the bottom,
7
Figure 5
with the ejector
Advertisement
Table of Contents
