Table of Contents
Advertisement
Figure 5 Reversely insert an OAP card
Push the OAP card slowly along the guide rails (see callout 3 in
Step4
6) and then push the ejector levers inward to lock the OAP card in
position (see callout 4 in
Figure 6 Install the OAP card to the switch
(4)
(1) OAP card
(3) Insertion direction of the OAP card
CAUTION:
When installing the OAP card, note the following guidelines:
Do not touch the components on the surface of the OAP card.
Do not apply excessive force while installing the OAP card. If you cannot
insert the OAP card smoothly, check whether the installation mode
(reverse insertion) is correct.
Fasten the captive screws on the OAP card with the Philips screwdriver
Step5
until the OAP card is fixed into the chassis.
Remove an OAP card
Follow these steps to remove an OAP card:
Figure
(1)
(3)
6).
(2)
(2) Rear panel of the switch
(4) Locking direction of the ejector levers
8
Figure
Advertisement
Table of Contents
