Operation Warnings - Sony PDW-F355L Operating Instructions Manual

Operation Warnings

When a problem occurs at power on or during operation, a
warning is given by one of the following.
• Warning indicators in the status display on the LCD
monitor
• WARNING indicators, and audible warnings from the
speaker and earphones
Status WARNING
display on indicator
the LCD
monitor/
viewfinder
screen
Warning
: Continuous
indication
: 1 flash/s
: 4 flashes/s
1)
E**-**
MEM Full!
2)
ILL.REC!
2)
Disc Error!
2)
HUMID!
2)
2)
Before Full
2)
Near MAX #
2)
Warning Indicators in the
sound viewfinder
Continuous REC/
beep TALLY
: Continuous
1 beep/s
: 1 flash/s
4 beeps/s
: 4 flashes/s
2)
2)
2)
2)
2) 2)
2) 2)
3)
2)
(only
when
recording
the 300th
4)
clip)
• Indicators on the viewfinder
The volume of the audible warnings can be adjusted with
the ALARM knob. Set the ALARM knob to the minimum
position to suppress the sound.
Problem VDR operation
BATT
– Recording Recording stops.
error
– Shockproof Recording
memory continuous but may
overflow be substandard.
– Input sync Recording
error continuous but may
be substandard.
– A disc defect Recording
was detected. continues, avoiding
the defect, but may
be substandard.
– Condensation Recording/playback
on the optical continues but stops
pickup. when an error
occurs on the drive.
– Disc almost Operation
full. continues.
– Nine or fewer Operation
clips remain continues.
until the upper
limit of 300
recorded clips
is reached.
Action to take
Turn off the power
and consult your
Sony dealer.
Protect the unit
from shocks and
vibration.
Turn off the power
and contact your
Sony dealer. (This
indication may be
given momentarily
when a GENLOCK
signal is connected
or disconnected,
but this does not
indicate a problem.)
If defects are
detected
repeatedly,
exchange the disc.
Stop recording/
playback, turn off
the power, then turn
it on again, and wait
until the HUMID
indicator
disappears.
Be prepared to
change the disc.
Be prepared to
change the disc.
167
Operation Warnings