Related Manuals for Soleus Air SOLEUSAIR SG-TTW-09ESE-26
Summary of Contents for Soleus Air SOLEUSAIR SG-TTW-09ESE-26
- Page 1 Models SG-TTW-09ESE-26 SG-TTW-12ESEZ-26 SG-TTW-09HC-26 SG-TTW-12HC-26 Electronic Through the Wall Air Conditioner Operating Instructions...
-
Page 2: Table Of Contents
Unpacking The Unit ... 1 Operating Instructions ... 1 Installation Instructions ..2 Wiring ..5 Air Conditioner Features... 6 Additional Things You Should Know..13 Normal Operating Sounds and Conditions ... 13 Obtaining Service ... 1 Warranty... -
Page 3: Specifications
Specifications • Noise level is measured at a distance of 3.28ft away from the front of the unit in cooling mode. • Power consumption is measured when the fan runs at the highest speed settings. • These specifications are for reference only. For actual data, please refer to the rating label on the unit. Model Number Power Supply (Ph/V/Hz) Dehumidifying Capacity (Pt/Day) -
Page 4: Important Note To The Owner
IMPORTANT NOTE TO THE OWNER This equipment is to be serviced by professionally trained personnel only. If this equipment is improperly installed, adjusted or altered by an unqualified person, a safety hazard may result. IMPORTANT NOTE TO THE SERVICER Read this manual and familiarize yourself with the specific items which must be adhered to before attempting to service this unit. -
Page 5: Installation Instructions
WARNING To prevent electrical shock, property damage, personal injury, or death, do not remove grounding prong from plug. Follow all operating instructions. Installation Instructions To ensure that the unit operates safely and efficiently, it must be installed, operated, and maintained according to these installation and operating instructions and all local codes and ordinances, or, in their absence, with the latest edition of the National Electrical Code. - Page 6 Figure 3 3. Remove shipping pads inside air conditioner next to compressor. (See Figure B.) Figure B 4. Carefully slide the chassis into the sleeve. Ensure that the ground wire is not pinched or in the path of the condenser fan.
- Page 7 To replace front grille: Hook the tabs on the front grille even with the tabs on the case and snap into place. Replace the screws and filter. Refer to Page 4, Figure A. VENT CONTROL AND AIR DIRECTION (See Figure E) The vent control is located behind the front grille on the right side of the air discharge area.
-
Page 8: Wiring
If air is obstructed and/or deflected back into the unit, the air conditioner’s compressor may cycle on and off rapidly. This could cause damage to the compressor. -
Page 9: Air Conditioner Features
Air Conditioner Features LOWERS TEMPERATURE OR TIME RAISES TEMPERATURE OR TIME SETS FAN SPEED SETS MODE SLEEP MODE LOWERS TEMPERATURE OR TIME RAISES TEMPERATURE OR TIME SETS FAN SPEED SETS MODE SLEEP MODE ELECTRONIC CONTROL OPERATING INSTRUCTIONS Before you begin, thoroughly familiarize yourself with the control panel and remote as shown below and all its functions. -
Page 10: Operating The Remote Control
OPERATING THE REMOTE CONTROL • Press the ON/OFF button to turn the A/C on or off. When the unit is turned off, the Timer and sleep functions will be cancelled. The set temperature will be saved. • Press the MODE button to change the operating mode. - Page 11 OPERATING THE REMOTE CONTROL • Press the “+” button to increase the temperature when the unit is on. Press and hold the “+” button for more than 2 seconds to quickly cycle through the temperature options. Stop pressing the button when the desired temperature is displayed.
-
Page 12: About Switch Between Fahrenheit And Centigrade
Air Conditioner Features Guide for operation- General operation 1. To power on the unit, press the ON/OFF button. The unit will start to run. (Note: When it is powered off, the louvers will close automatically.) 2. Press MODE button, select desired running mode, or press COOL or HEAT mode to enter into the corresponding operation directly. - Page 13 Air Conditioner Features TO TURN UNIT ON: TO CHANGE TEMPERATURE SETTING: Note: Tap or hold either up(^) or down(v) button until the desired temperature is seen on display. This temperature will be automatically maintained anywhere between 61F (16 C) and 86F (30 C) for both cooling and heating modes.
- Page 14 The temperature will automatically be maintained anywhere between 61°F (16°C) and 86°F (30°C). When the set room temperature is reached, the fan will cycle off and on to circulate and sample the room air. If the air conditioner is off and is then turned on while set to a Cool setting or if turned from a fan setting to a Cool setting, it may take approximately 3 minutes for the compressor to start and cooling to begin.
- Page 15 Air Conditioner Features (continued) HEATING FEATURE (on some models) Note: This feature can be used with any combination of FAN Speeds, Timer, or Sleep Modes. When in the “Heat” Mode, the fan will run continuously while heat is needed. The temperature will automatically be maintained anywhere between 61°F (16°C) and 86°F (30°C).
-
Page 16: Additional Things You Should Know
OUTDOOR COIL CLEANING The coils on the outdoor side of the air conditioner should be checked regularly. For cleaning outside coil, remove the 6 screws that mount the condenser coil top cover to condenser shroud. -
Page 17: Warranty
One Year Limited Warranty Soleus International, Inc. warrants the accompanying Soleus Air Powered by Gree Air Conditioner to be free of defects in material and workmanship for the applications specified in its operation instruction for a period of ONE (1) year from the date of original retail purchase in the United States.