B
Cables
Pin
1
Receive Data plus (RD+)
and GND (Positive V
2
Receive Data minus (RD-) and
and GND (Positive V
3
Transmit Data plus (TD+)
and -48V feeding power (Negative V
6
Transmit Data minus (TD-)
and -48V feeding power (Negative V
4, 5, 7, 8 not used
Note: The "+" and "-" signs represent the polarity of the wires that make up each wire pair.
Straight-Through Wiring
If the twisted-pair cable is to join two ports and only one of the ports has an internal
crossover (MDI-X), the two pairs of wires must be straight-through. (When
auto-negotiation is enabled for any RJ-45 port on this switch, you can use either
straight-through or crossover cable to connect to any device type.)
You must connect all four wire pairs as shown in the following diagram to support
Gigabit Ethernet connections.
End A
B-2
Table B-1 10/100BASE-TX MDI and MDI-X Port Pinouts
MDI Signal Name
)
port
)
port
EIA/TIA 568B RJ-45 Wiring Standard
10/100BASE-TX Straight-through Cable
White/Orange Stripe
White/Green Stripe
1
2
3
4
White/Blue Stripe
5
6
7
8
White/Brown Stripe
Figure B-2 Straight-through Wiring
MDI-X Signal Name
Transmit Data plus (TD+)
and -48V feeding power (Negative V
Transmit Data minus (TD-)
and -48V feeding power (Negative V
Receive Data plus (RD+)
)
and GND (Positive V
port
Receive Data minus (RD-)
)
and GND (Positive V
port
not used
Orange
Blue
Green
Brown
)
port
)
port
)
port
)
port
1
2
End B
3
4
5
6
7
8