Connecting To Pcs, Servers, Hubs And Switches; Network Wiring Connections; Figure 4-1 Making Twisted-Pair Connections - SMC Networks SMC TigerSwitch 10/100/1000 SMC8124PL2 Installation Manual

4
Making Network Connections
See Appendix B: for further information on cabling.
Caution: Do not plug a phone jack connector into an RJ-45 port. This will
damage the switch. Use only twisted-pair cables with RJ-45 connectors
that conform to FCC standards.

Connecting to PCs, Servers, Hubs and Switches

1. Attach one end of a twisted-pair cable segment to the device's RJ-45
connector.
2. If the device is a PC card and the switch is in the wiring closet, attach the other
end of the cable segment to a modular wall outlet that is connected to the wiring
closet. (See "Network Wiring Connections" on page 4-2.) Otherwise, attach the
other end to an available port on the switch.
3. Make sure each twisted pair cable does not exceed 100 meters (328 ft) in
length.
4. As each connection is made, the Link LED (on the switch) corresponding to
each port will light green (1000 Mbps) or amber (10/100 Mbps) to indicate that
the connection is valid.

Network Wiring Connections

Today, the punch-down block is an integral part of many of the newer equipment
racks. It is actually part of the patch panel. Instructions for making connections in the
wiring closet with this type of equipment follows.
4-2

Figure 4-1 Making Twisted-Pair Connections