Installation Tools - Trane RTHC-SVN02C-EN Installation Manual

Table 1 Valves Available
Trane Part Number
VAL06912
VAL06913
VAL06914
VAL06915
VAL06916
VAL06917
VAL06918
VAL06919
2
Discussion
The purpose of this manual is to outline the installation and setup procedures for the
regulating valve and the associated controller for optimal condensing water control.
The condenser water regulating valve option can be ordered with or without the water
regulating valve. Just the controls and pressure transducers can be ordered if an valve
and electric actuator are already available . This manual will cover installation of the
water regulating valve, the controller and the pressure transducers.
Condenser Water Regulating Valve
The optional condenser water regulating valve is produced by Center Line. Below is a
basic installation procedure for installing the valve. For detailed instructions, refer to
the "Center Line Installation and Maintenance Instructions for UL Approved Valves"
found on the internet at http://www.cranevalve.com.
Crane Series Number
06B1021319-44300M-20A
08B1021319-44300M-20B
06B1021319-44300M-20A-220VAC
08B1021319-44300M-20B-220VAC
06M2521319-44300M-20A
08M2521319-44300M-20B
06M2521319-44300M-20A-220VAC
08M2521319-44300M-20B-220VAC
Water Valve Rating
Confirm that the correct valve was shipped by referring to the Center Line nameplate
attached to the valve body. Refer to Table 1 for the list of valves available.

Installation Tools

A hoist will be necessary to manipulate the valve into place and a wrench suitable for
tightening the flange bolts and/or nuts. Temporary pipe supports maybe used to keep
flange faces parallel during installation.
Rating Actuator
(PSIG) Voltage (AC)
200 115
200 115
200 220
200 220
300 115
300 115
300 220
300 220
Valve Size
(inches)
6
8
6
8
6
8
6
8
RTHC-SVN02C-EN