Wcdma Receiver Tunings; Rx Calibration (Wcdma) - Nokia 6600 slide Service Manual

RM-414; RM-570
RF troubleshooting

WCDMA receiver tunings

RX calibration (WCDMA)

Context
Rx calibration tuning routine calculates the real gain values of the WCDMA Rx AGC system. There is also a SAW
filter between front end LNA and mixer in the receive chain, which causes ripple in the RSSI measurement,
this is calibrated out. The SAW filter is intergated into RF ASIC N7500.
Rx calibration can be done in two different ways, manual tune and sweep mode tune. If the signal generator
in use supports frequency sweep table, the calibration is done in one step.
Steps
1. For manual tuning, set mode to Local in the Operating Mode dropdown menu.
2. In the Tuning menu, choose WCDMA→Rx Calibration .
3. Click Start.
4. Select Band "WCDMA2100 or WCDMA850".
5. Click Tune.
Rx Calibration pop-up window and click
6. Setup the signal generator to correspond with the values on the,
OK.
Figure 26 Pop-up window for WCDMA2100
Page 4 –40 COMPANY CONFIDENTIAL Issue 2
Copyright © 2009 Nokia. All rights reserved.