To Advance Trimmer Line; Remove Nylon Line Head - Shindaiwa X7502825900 Owner's/Operator's Manual

Cutting attachment shield
Tools Required: Screwdriver
Parts Required: Plastic debris shield, shield plate, (3) 5 x 10 mm screws
CAUTION
Wear Gloves or personal injury may result:
• Cutoff knife is sharp.
• Gearcase and surrounding area may be hot.
The plastic shield is for use with the Nylon Line Head only. Install Metal
Shield when using plastic or metal blades.
1. Remove plastic threaded shaft sleeve and adapter plate (C) from
PTO shaft (A).
2. Place the shield on the bottom of the bearing housing flange.
3. Place shield plate (B) on shield, align holes. Install three (3) screws
from bottom through plate and shield into gear case.
Install trimmer head
Tools required: 4 mm hex key wrench (locking tool)
Parts required: adapter plate, trimmer head
Use the 4 mm hexagonal wrench as a gear housing locking tool.
1. Assemble adapter plate (C) onto PTO shaft.
2. Align locking hole in adapter plate with notch in edge of gear housing
and insert head locking tool (D).
3. Thread line head (E) onto shaft by turning it counter-clockwise until
head is tight against adapter plate (C).
4. Remove locking tool (D).
Semi-automatic nylon line heads must be used only with plastic debris shield
with cut-off knife. Using nylon line heads with metal debris shield can result
in trimmer damage, caused by operation with excessive line length.

To advance trimmer line

To advance trimmer line, tap trimmer head against the ground while the head
is turning at normal operating speed.
Nylon line replacement
See Maintenance Section for Loading Trimmer Line.

Remove nylon line head

Do not disassemble nylon line head.
1. Align locking hole in adapter plate with notch in edge of gear housing and insert head locking tool (D).
2. Remove line head (E) by turning it clockwise until head is completely off of shaft.
3. Remove locking tool (D).
NOTE:
NOTE:
IMPORTANT!
Tip:
NOTE:
A
B
C
D
A
C
D
E
7