Sherwood Newcastle R-956 Operation Instructions Manual page 30

Entering a video label
This function can be operated only on video input
sources such as VIDEO 1~5.
Select the desired video input source to
enter its label.
1
VIDEO
or
VID SEL
Select the character on the flickering digit.
3
MULTI CONTROL
Each time the MULTI CONTROL knob is rotated,
the characters change as follows;
Blank ( )
Alphabets: A~Z, a~z
Numerals: 0~9
Symbols:
Memorize the desired video label.
6
Correcting or clearing a video label
Select the desired video input source to be
rectified or cleared.
1
VIDEO
or
VID SEL
PWR
AUD AUD CD DVD AUX
SAT SAT TV VCR CBL
1 2 3
4 5 6
7 8 9
MUTE 0 CH SEL
P.SCAN
SLEEP
VOL VOL CH LEVL
T.TONE
D.TIME D.ADJ
ENTER
OSD
AUTO STEREO
DSP MODE 6.1CH IN
PHONO CD TUNER TAPE MON
T2 MON VID SEL VID 2 VID 3
VID 4 VID 4 AUX ROOM 2 SYS DISP
HOME THEATER MASTER
RNC-30
Note: If any button such as "AUDIO", "VIDEO" , "6.1
PWR
AUD AUD CD DVD AUX
SAT SAT TV VCR CBL
1 2 3
4 5 6
7 8 9
MUTE 0 CH SEL
P.SCAN
SLEEP
VOL VOL CH LEVL
T.TONE
D.TIME D.ADJ
ENTER
OSD
AUTO STEREO
DSP MODE 6.1CH IN
PHONO CD TUNER TAPE MON
T2 MON VID SEL VID 2 VID 3
VID 4 VID 4 AUX ROOM 2 SYS DISP
HOME THEATER MASTER
RNC-30
3 0
Press the VIDEO LABEL button to enter the
video label mode.
2
Example) When selecting VIDEO 1.
VIDEO LABEL
Confirm your selection.
4
VIDEO LABEL
Then the next digit flickers.
Repeat the above steps 3 and 4 to enter the
desired characters on the next digits.
5
You can enter up to 9 characters for each of the
video inputs.
CH DIRECT" button, etc. is pressed while entering
a video label, the video label mode will be
canceled.
MEMO/ENTER
Repeat the steps 2~6 in "Entering a video
label" procedure.
2
To clear a video label, make a blank on each digit
and memorize it, then the video label is cleared and
its factory video input source will be displayed.
If the VIDEO LABEL button is pressed for more
than 3 seconds, blanks will be made on all the digits
at once.