Sherwood Newcastle R-956 Operation Instructions Manual page 15

When CD, TAPE MON or VIDEO 1~
VIDEO 4 is selected
Select the digital or the analog input
connected as desired.
4
DIGITAL/ANALOG
Each time this button is pressed, the corresponding
input is selected as follows;
DIGITAL ANALOG
To listen to DTS or Dolby Digital program sources
in the 2-CH downmix mode (the stereo mode), the
digital input must be selected. (For details, refer to
"Downmixing into 2 front channels" on page 22.)
When PHONO, TUNER, VIDEO 5 or AUX is
selected as an input source, the analog input is
selected automatically.
Note:
When the selected digital input is not connected or
has no sound, "DIGITAL" flickers indicating the
lack of sound. (refer to "ENJOYING SURROUND
SOUND" on page 19.)
Operate the selected component for
playback.
5
To play back the program sources in surround
sound, refer to "ENJOYING SURROUND
SOUND" on page 19.
Adjust the (overall) volume.
6
MASTER VOLUME
VOL
or
DOWN
UP
Adjusting the tone (bass and treble)
7
"DIRECT ON" or "DIRECT OFF" is shown for 5
seconds.
8
Each time the MULTI CONTROL knob is rotated,
the tone mode changes as follows:
DIRECT ON: When listening to a pure program
DIRECT OFF: When adjusting the tone for your
When "DIRECT ON" is selected.
"DIRECT" lights up, meaning the tone direct
function is activated and the sound that bypasses the
tone circuitry will be heard.
To cancel the tone direct function, select "DIRECT
OFF" performing the above steps 7 and 8.
When "DIRECT OFF" is selected.
1) Select the tone mode as desired.
Each time this button is pressed, the mode changes
as follows;
BASS
2) At the desired tone, adjust as desired.
In general, we recommend the bass and the treble to
be set to 0(flat) level.
To complete tone adjustment, repeat the above steps
PWR
1) and 2).
AUD AUD CD DVD AUX
SAT SAT TV VCR CBL
1 2 3
Notes:
4 5 6
7 8 9
MUTE 0 CH SEL
P.SCAN If the tone display disappears, start from the step 7
SLEEP
VOL VOL CH LEVL
T.TONE
again.
D.TIME D.ADJ
ENTER
Extreme settings of the tone controls at high volume
OSD
AUTO STEREO
DSP MODE 6.1CH IN
may damage your speakers.
PHONO CD TUNER TAPE MON
T2 MON VID SEL VID 2 VID 3
VID 4 VID 4 AUX ROOM 2 SYS DISP
In DTS or Dolby Digital modes, the tone controls
HOME THEATER MASTER
RNC-30
cannot be adjusted and the tone direct function is
activated automatically .
1 5
Enter the tone mode.
TONE MODE
Select the tone mode as desired.
MULTI CONTROL
source without the tone effect.
taste.
TONE MODE
TREBLE DIRECT OFF
MULTI CONTROL