Fm Set; Rec Set - Netac iMuz C700 User Manual

4.6.4 FM SET

Enter FM SET window, you can select the RADIO MODE, FM BAND
MODE or SENSITIVITY.
Press VOL+ / VOL- button to set the output signal as STEREO or MONO in RADIO MODE.
STEREO: The output of frequency module is stereo signal;
MONO: The output of frequency module is mono signal.
Press "VOL+" / "VOL-" button to set the FM band mode as WORLD or JAPAN in FM BAND MODE.
JAPAN: The reception band is 76~108MHZ;
WORLD: The reception band is 87.5~108MHZ.
Press "VOL+" / "VOL-" button to set the SENSITIVITY as LOW,
MID or HIGH when automatic searching station.

4.6.5 REC SET

Enter REC SET, you can set SYCHRONOUS of LINE-IN recording, and
bit rate of each recording status.
Press "VOL+" / "VOL-" button to set whether or not to record
synchronously in LINE-IN recording.
OFF: The input signal are recorded into one and the same file
when recording continuously;
ON: iMuz would stops recording and make a new file to start
another record when the input signal has whisht interval over 3
seconds.