Lan - D-Link BROADBAND DSL-2740B User Manual

Section 3 - Configuration
You can configure the LAN IP address to suit your preference. Many users will find it convenient to use the default settings together with DHCP
service to manage the IP settings for their private network. The IP address of the Router is the base address used for DHCP. In order to use the
Router for DHCP on your LAN, the IP address pool used for DHCP must be compatible with the IP address of the Router. The IP addresses
available in the DHCP IP address pool will change automatically if you change the IP address of the Router.
To access the LAN setting window, click the LAN button in the Setup directory.
To change the LAN IP Address or Subnet Mask, type in the desired
values and click the Save Settings button. You will be asked to reboot by
a pop-up window. Click OK to reboot the router.
You might need to re-configure your PC NIC settings to enter the Router's
web manager after reboot.
When enabled, it allows other devices that support
UPnP:
UPnP to dynamically join a network, obtain an IP
address, convey its capabilities, and learn about the
presence and capabilities of other devices.
IGMP IGMP snooping is a feature that allows the layer-2
device (switch) to "listen in" on the IGMP conversation
Snooping:
between hosts and routers.
Standard Mode: Listen and forward
Blocking Mode: Listen and block
The DHCP server is enabled by default for the Router's Ethernet
DHCP:
LAN interface. DHCP service will supply IP settings to workstations
configured to automatically obtain IP settings that are connected to
the Router though the Ethernet port. When the Router is used for
DHCP it becomes the default gateway for DHCP client connected to
it. Keep in mind that if you change the IP address of the Router the
range of IP addresses in the pool used for DHCP on the LAN will
also be changed. The IP address pool can be up to 253 IP
addresses.
D-Link DSL-2740B User Manual

LAN

30