AGFA DX-D 300 User Manual page 80

80 | DX-D 300 | Remarks for HF-emission and immunity
The DX-D 300 system is intended for use in the electromagnetic environment
specified below. The customer or the user of this DX-D 300 system should
assure that it is used in such an environment.
Table 2: Guidance and manufacturer's declaration on electromagnetic
emissions (IEC 60601-1-2)
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations / flick-
er emissions
IEC 61000-3-3
Note: In accordance with Standard IEC 61601-1-2, the emissions character-
istics of this equipment make it suitable for use in industrial areas and hospi-
tals (CISPR 11 Class A. If it is used in a residential environment (for which
CISPR 11 Class B is normally required) this equipment might not offer ade-
quate protection to radio-frequency communication services. The user might
need to take mitigation measures, such as relocating or re-orientating the
equipment.
The DX-D 300 system is intended for use in the electromagnetic environment
specified below. The customer or the user of this DX-D 300 system should
assure that it is used in such an environment.
0172E EN 20181116 1653
interferences shown in General Regulation for safety according
to IEC 60601-1-2 tables as described in this section.
CAUTION:
The manufacturer is not responsible for any interference caused
by using other than recommended interconnect cables,
accessories and transducers or by unauthorized changes or
modifications to this equipment.
Emission test Compli- Electromagnetic environment
ance
Group 1 The device uses RF energy only
for its internal function. There-
fore, its RF emissions are very
low and are not likely to cause
any interference in nearby elec-
tronic equipment.
Class A The device is suitable for use in
all establishments other than
domestic and those directly con-
nected to the public low-voltage
Class A
power supply network that sup-
plies buildings used for domes-
tic purposes.
Complies
- guidance