Sanyo KHS0951 Instruction Manual page 9

Program button
TIMER SELECT button
MODE selector button
(AUTO)
(COOL)
FLAP button
FAN SPEED selector button
1 HR. TIMER button
(1-HOUR OFF TIMER)
ACL button (ALL CLEAR)
ADDRESS switch
SENSOR button
NOTE The remote control unit sends the temperature signal to the air conditioner regularly at five minute intervals.
If the signal from the remote control unit stops for more than ten minutes due to the loss of the remote
control unit or other trouble, the air conditioner will switch to the temperature sensor which is built into
the indoor unit and control the room temperature. In these cases, the temperature around the remote
control unit may differ from the temperature detected at the air conditioner's position.
OI-351-9EG
Remote Control Unit (continued)
For details, see "Setting the Timer" .
Press this button to select the mode you want to program.
No display : The timer does not operate.
: The air conditioner stops at the set time.
: The air conditioner starts at the set time.
: The air conditioner stops and starts, or starts and stops, at the
set times every day.
Use this button to select the AUTO, HEAT, DRY or COOL mode.
: When this setting is selected, the air conditioner calculates the
difference between the thermostat setting and the room temperature
and automatically switches to the "COOL " or "HEAT" mode as
appropriate.
(HEAT) : The air conditioner makes the room warmer.
(DRY) : The air conditioner reduces the humidity in the room.
: The air conditioner makes the room cooler.
Press this button either to select to set the airflow direction to one of the six
possible positions manually, or to select the sweep function, which moves
the flap up and down automatically.
: The airflow direction can be set manually. (six positions)
: The flap moves up and down automatically.
NOTE When you press the FLAP button, the air flow direction will be changed one
by one as follows.
Swing
: The air conditioner automatically decides the fan speeds.
: High fan speed
: Medium fan speed
: Low fan speed
: When you press this button, regardless of whether the unit is
operating or stopping, the unit operates for one hour and then
shuts down.
Puts the remote control unit into pre-operation status. Always press this
button after replacing the batteries.
Change the address switch to prevent mixing of signals from remote control
•
units when two Sanyo air conditioners are installed next to each other.
Normally, the address switch is set to A. When switching the address, the
remote control must be changed, and the jumper cables on the indoor unit
board must be cut. For more information, please contact the dealer where
you made the purchase.
Normally, the tabs on the remote control unit should not be bent.
•
When you press this button (use a small-tipped object such as a ballpoint
pen), the mark will appear at the display. And the room temperature is
detected by the sensor which is built into the indoor unit and the air
conditioner is controlled accordingly.
NOTE If the remote control is located near a heat source, such as a space heater or
in direct sunlight, press the SENSOR button to switch to the sensor on the
indoor unit.
9