Adjusting The Fan Speed - Sanyo KHS0951 Instruction Manual

NOTE
3. Adjusting the
Fan Speed
A. Automatic
Cooling and DRY mode:
Heating mode:
NOTE
B. Manual
OI-351-15EG
Operation with the Remote Control Unit (continued)
This appliance has a built-in 3-minute time delay circuit to ensure
•
reliable operation. When the operation button is pressed, the
compressor will start running within three minutes. In the event of
power failure, the unit will stop. When the power is restored, the unit
will restart automatically after five minutes.
Simply set the FAN SPEED selector button to the
A microcomputer in the air conditioner automatically controls the fan speed
when the mode is selected. When the air conditioner starts operating,
the difference between the room temperature and the set temperature is
detected by the microcomputer which then automatically switches the fan
speed to the most suitable level.
When difference between
room temperature and set
temperature is
4 F and over
Between 4 F and 2 F
Below 2 F
When difference between
room temperature and set
temperature is
4 F and over
Below 4 F
The above mentioned data make reference to the conditioner operating
when the sensor on the remote control unit is ON. (Refer to temperature
sensor selector). If the sensor on the indoor unit is being used then
actual operation will slightly differ from that described in the above
tables. ( Sign shown on the remote control unit display.)
If you want to adjust fan speed manually during operation, just set the FAN
SPEED selector as desired. [
position.
FAN SPEED
High
Medium
Low
FAN SPEED
High
Medium
, , or ]
15