Sanyo KHS0951 Instruction Manual page 11

Split system air conditioner cool/dry/heat model
Table of Contents

Advertisement

Mounting the Remote
Control Unit
When attaching to wall
When using the remote
control unit
Securing the remote
control unit to prevent theft
OI-351-11EG
Using the Remote Control Unit (continued)
Truss-head
tapping screws
5/32 x 5/8 " (4 x 16 mm)
(supplied)
Remote
control
unit holder
1)
Confirm the indoor unit beeps when the ON/OFF button is pressed at
the wall location where the remote control unit is to be attached, then attach
the holder to the wall.
2) When taking out the remote control unit, pull it from the holder.
Point the transmitter on the remote control unit at the sensor on the
indoor unit when operating the remote control unit and the air conditioner.
Do not place objects which may block the transmitted signals between
the receiver and the remote control unit.
Truss-head
tapping screws
5/32 x 5/8 " (4 x 16 mm)
(supplied)
Remote
control
unit holder
1) Attach the holder to the wall with one screw in the upper hole only.
2) Remove the cover from the remote control unit, and then remove the
batteries. Next, place the remote control unit in the holder.
3) Secure both the remote control unit and the holder to the wall with another
screw through the lower hole.
4) Put the batteries back in the remote control unit, and then replace the
cover.
Press
Hook
Holder
11

Advertisement

Table of Contents
loading

This manual is also suitable for:

Khs1251Khs1852

Table of Contents