Changing Midi Settings - Casio CTK-491 User Manual

TRANSPOSE/TUNE/MIDI
PROGRAM CHANGE
This is the tone selection message. PROGRAM CHANGE can
contain tone data within the range of 0 to 127.
A PROGRAM CHANGE message (0 to 99) is sent out through
this keyboard's MIDI OUT terminal whenever you manual-
ly change its tone number. Receipt of a PROGRAM CHANGE
message from an external machine changes the tone setting
of this keyboard (this page).
This keyboard can send tone data within the range of 00 to
99 and receive tone data within the range of 0 to 127.
PITCH BEND
This message carries pitch bend information for smoothly
sliding the pitch upwards or downwards during keyboard
play. This keyboard does not send pitch bend data, but is can
receive such data.
CONTROL CHANGE
This message adds effects such as vibrato and volume changes
applied during keyboard play.
CONTROL CHANGE data includes a control number (to
identify the effect type) and a control value (to specify the
on/off status and depth of the effect).
The following is a list of data that can be received using
CONTROL CHANGE.
Effect
VOLUME
HOLD1 *
MODULATION
* Pressing the foot pedal causes the sustain effect (HOLD1) to
be sent (control number 64).
E-32
CTK481_E31_33.p65
Control Number
7
64
1
Page 32
[+]/[–]

Changing MIDI Settings

This keyboard lets you change the settings of two MIDI pa-
rameters: TONE MAP and KEYBOARD CHANNEL.
To change MIDI parameters
1.
Press the TRANSPOSE/TUNE/MIDI button ei-
ther three or four times to select the parameter
you want.
Press the TRANSPOSE/TUNE/MIDI button three
times: KEYBOARD CHANNEL
Press the TRANSPOSE/TUNE/MIDI button four times:
TONE MAP
Example: To select the TONE MAP parameter.
2.
Use [+] and [–] to change the setting of the pa-
rameter.
Example: To change the TONE MAP parameter value
to "G" (GM).
• If you accidentally go past parameter you want, keep
pressing the TRANSPOSE/TUNE/MIDI button un-
til parameter you want reappears on the display.
• If you leave the parameter selection screen on the dis-
play for about five seconds without doing anything,
the parameter selection screen is automatically
cleared.
03.10.7, 2:58 PM
Adobe PageMaker 6.5J/PPC
625A-E-034A