Table of Contents
Advertisement
④ [Age Time] on [Bridge Table] Management Box shows cycle of AP refreshing
"Bridge Table". The use of Default Values is recommended.
⑤ After selecting Station Type you want with Radio button to refresh Stations
connected to current AP, click [Refresh Bridge Table] button to confirm.
Confirm Refresh
Bridge Table
Number
of
Stations
⑥ [Bridge Table] Management Box enables confirmation of Wired and Wireless
Stations connected with current AP only.
⑦ You can block Protocol you do not want using [Protocol] Management Box.
When Protocol use is limited, some specific applications may not operate.
Therefore, before setting, consult your system administrator. "Disabled" of
Default Value is recommended.
⑧ Selecting "Disabled" checkbox on [Protocol] Management Box leads to
"Enabled". Then, whole [Protocol] Management Box is activated to enable
selecting.
⑨ If you select any Protocol what you do not want among Protocols shown on
[Protocol] Management Box, a phrase of "Pass" changes to "Drop".
Radio Button
for
Station Type
20
Selecting
MAC Address Information
of Connected Stations
Advertisement
Table of Contents
