Related Manuals for Neilsen CT2215
Summary of Contents for Neilsen CT2215
- Page 1 80LB TOW-BEHIND SPREADER CT2215 Ref no. SP31507 ORIGINAL INSTRUCTIONS SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE Cannon Tools Limited Address: 20 Station Road, Rowley Regis, West Midlands, B65 0JU.U.K.
-
Page 2: Ec Declaration Of Conformity
In case of alteration of the machine, not agreed upon by us, this declaration will lose its validity. Product description: TWO BEHIND SPREADER Model: CT2215 (Ref no. SP31507) Applicable EC Directives: EC Machinery Directive 2006/42/EC Harmonized standards... -
Page 3: Safety Rules
ASSEMBLY AND OPERATION INSTRUCTION 1. SAFETY RULES READ THE DIRECTIONS BEFORE ASSEMBLY Read the towing vehicle owners manual and towing vehicle safety rules. Know how to operate your tractor before using the tow-behind spreader. Read the chemical label instructions and cautions for handling and applying the chemicals purchased for spreading. - Page 4 STEP1： Install Impeller onto the Gear Box & Axle Assembly. Insert Round Head Bolt M4x20 through impeller then through Gear Box Axle.
- Page 5 STEP 2: M6x35...
- Page 6 STEP3： Install one end of the connecting plate on the wheel frame by Bolt M6x35 and Lock Nut M6. Then install the connecting rod on the wheel frame by Bolt M6x55 and Lock Nut M6 and fixed the connecting plate with connecting rod by Bolt M6x35.
- Page 7 STEP 4: Insert Inner Axle Bushing into Outer Axle Bushing and make sure they are tight neatly. Install right Wheel Assembly to right Axle using inner hex bolt M5x45 and lock nut M5, and then install the Cap onto right Axle using a wooden or rubber hammer.
- Page 8 STEP5: Put the install tube assembly to hopper assembly using Bolt M6x40 and Lock Nut M6.NOW GO BACK AND TIGHTEN ALL NUTS AND BOLTS STARTING WITH FIRST STEP. DO NOT OVER TIGHTEN...
- Page 9 STEP6: ADJUSTMENTS. When you finished all above steps, You don't need to do the following steps. If they are not match neatly, you may need to do the following steps. To operate this spreader, push the handle to the top position (upwards). You may move the position of Wing nut on Gauge & Lever to adjust the spacer of three holes between hopper and adjustable plate as per your need when spreading.
-
Page 10: Parts Drawing
PARTS DRAWING... -
Page 11: Parts List
PARTS LIST Ref.No. Drawing No. Description 9114-06025-DG Carriage Bolt M6x25 9315-08000-DG Tooth Washer Ø8 N570-10000-DG Gauge & Lever Assembly N580-00005-DG Adjust Handle Pole N570-00014 Adjust Handle A N570-00015 Adjust Handle B 9118-04018-DG Screw M4x18 N511-00004 Hopper Screen N510-00016 Spacer N510-00019 Wing Nut M6 N580-00006 Hopper... - Page 12 PARTS LIST Ref.No. Drawing No. Description 9105-05045-DG Inner Hex Bolt M5x45 N570-00018 Inner Axle Bushing N570-00011 Outer Axle Bushing N511-30000 Gear Box & Axle Assembly 9110-04020-DG Screw M4x20 9302-06000-DG Big Flat Washer Ø6 C130-00004 Nylon Washer N580-00009 Line Clamp Press Plate N511-20000 Control Rod N510-00023...