Table of Contents
Advertisement
Recording Your Keyboard Play
6START/STOP
You can record your music as you play and store up to
five songs in Digital Piano memory for later playback.
You can divide a song into parts (by instrument, by left
hand and right hand, etc.) and record each part
separately. You can even use "punch-in recording
edit specific parts of existing recordings.
Recording or Playing Back a
Single Song
The following are the steps for recording or playing
back a single recorder memory song.
1.
Press the
(RECORDER) button twice so
its lamp is flashing.
This turns on the recorder and enters record mode.
• Each press of the
through modes as shown below.
Recorder Off
Unlit
Lit: Playback mode
2.
Configure the tone, rhythm, and other
settings you want to use.
• The settings you configure here will be included as
part of the recorded song data.
• For details about what is included in the recorded
song data, see "System Track" (page E-35).
3.
Play something on the keyboard.
Recording starts as soon as you play something.
• If Auto Accompaniment is playing, it will be
included in the recorded data.
E-34
9RECORDER
(RECORDER) button cycles
Recorder On
Flashing: Record mode
4.
When you are finished, press the
STOP) button.
This will cause the
then light, indicating the playback mode.
to
"
• If you are using Auto Accompaniment, you also can
end the recording session by pressing the
(ENDING) button.
5.
To play back what you have recorded, press
(START/STOP) again.
• Each press of
6.
To turn off the recorder, press the
(RECORDER) button so its lamp goes out.
NOTE
• Recorder memory capacity is approximately 10,000
notes per song. When remaining capacity is 100
notes or less, the
flash at high speed. Recording will stop
automatically when memory becomes full.
• Repeat, fast reverse, fast forward, pause, and tempo
adjustment during playback are the same as when
playing back user songs. See "Listening to Songs
Loaded from an External Source" (page E-25) for
more information.
• You can listen to the song data currently stored in
recorder memory at any time by pressing the
(RECORDER) button to enter the playback mode
and then pressing
btw/NO, q/YES
bsFUNCTION
ctu
(RECORDER) lamp to flash and
Lit: Playback mode
starts and stops playback.
Unlit: Recorder off
(RECORDER) button lamp will
(START/STOP).
dki
(START/
Advertisement
Table of Contents
