Configuration For Gatekeeper Mode - Siemens Hicom 150 H Service Manual

lan2de.c03
Startup
Initial startup of HiPath HG 1500

3.2 Configuration for gatekeeper mode

Figure 3-1
Group 1
Optiset 100
HiPath HG 1500
Hicom 150 E Office
The following stations must be differentiated from the user's viewpoint:
Group 1: stations directly connected to the Hicom (Optisets, POT, CMI, ...), stations
registered at HiPath HG 1500 (C55 Opti clients, vCAPI clients) and all trunk access-
es.
Group 2: stations registered at the gatekeeper (H.323 standard clients such as Net-
meeting 3.01, HiNet LP5100, HiNet TA1100, etc.).
Note
In order to reach a port (station/line) of group 1, all stations of group 2 must dial an
additional code. This code is deleted in the direction to the Hicom by HiPath HG 1500
and inserted for traffic in the reverse direction, i.e., stations of group 1 do not dial the
code.
The code must be set up in the RADVision Gatekeeper NGK100 as a service and in
HiPath HG 1500 as a gateway prefix.
3-4
Installation for gatekeeper mode
HXGM/HXGS
H.323 GK
H.323 client
200
Group 2
LP5100
201
For internal use only
HFA client
300
LAN
Administration
A31003-K5020-S100-6-7620
Service Manual