Function Test When Activating Alarm Mode And Png Mode - Siemens HiPath 3000 Operating Instruction

Step by Step
Function Test
Shake Sensor
Please shake
handset
Test Passed!
Function Test
Position Sensor
Please hold handset
in vertical position
Test Passed!
Function Test
Emergency Key
Please press
emergency key
Test Passed!
Function Test
Pull Cord Alarm
Function test when activating Alarm
Mode and PNG Mode
A function test has to be performed before the Alarm
Mode or PNG Mode is used. This test is performed
automatically by the handset.
Please follow the instructions on the display.
1. Test: Charge status of battery pack
If the battery pack is adequately charged, no reference
is made to the battery test.
If the battery charge is too low, the message "Battery
low!" appears, the entire function test is cancelled and
"Test Failed!" is displayed. Make sure the battery pack is
adequately charged and start the startup procedure
again!
2. Test: Alarm sensors (movement test)
Move the handset vigorously for a few seconds. An
acknowledgement tone signals that the test has ended.
Shown on display if the test was successful. If not, the
entire function test is cancelled and "Test Failed!" is
displayed. Start the startup procedure again.
3. Test: Alarm sensors (non movement and man
down test)
Hold the handset still for a few seconds or put it down.
An acknowledgement tone signals that the test has
ended.
Shown on display if the test was successful. If not, the
entire function test is cancelled and "Test Failed!" is
displayed. Start the startup procedure again.
4. Test: Alarm key
Press the red alarm key. An acknowledgement tone
signals that the test has ended.
Shown on display if the test was successful. If not, the
entire function test is cancelled and "Test Failed!" is
displayed. Start the startup procedure again.
5. Test: Pull Cord Alarm
This test is only performed if the Pull Cord Alarm is
activated on the handset.
161