Adjusting The Throttle Cable - Stihl KA 120 Instruction Manual

6 Adjusting the Throttle Cable

5.1.4 Fitting the Throttle Cable
NOTICE
Do not kink the throttle cable or lay it in tight radii
– make sure the throttle trigger moves freely.
► Position the throttle cable retainer (15) and
throttle cable (14) against the drive tube.
► Close the throttle cable retainer (15). The
retainer (15) snaps into place.
5.1.5 Adjusting the Throttle Cable
► Check adjustment of throttle cable – see chap‐
ter on "Adjusting the Throttle Cable".
0458-516-0121-B
15 14
14
15
15
5.1.6 Swiveling the Handlebar
Transport position
► Loosen the wing screw (3) and unscrew it until
the handlebar (7) can be rotated.
► Rotate the handlebar 90° counterclockwise
and then swing the handles down.
► Tighten down the wing screw (3) firmly.
Working position
► Reverse the sequence described above to
swing the handles up and turn the handlebar
clockwise.
6 Adjusting the Throttle
Cable
A properly adjusted throttle cable is the precondi‐
tion for correct operation in the full throttle, start‐
ing throttle and idle positions.
Adjust the throttle cable only after the unit is fully
assembled – the control handle must be in the
normal operating position.
English
90°
3
7
9