Stihl KA 120 Instruction Manual page 8

English
5.1.2 Securing the Handlebar
7
► Place the handlebar (7) in the lower clamp (1)
so that distance A is no more than 15 cm
(6 in).
► Place the upper clamp in position and hold
both clamp moldings together.
► Push the wing screw through the two clamps
as far as stop – hold all parts together and
secure them.
8
► Place the secured assembly on the handle
support (8) with the wing screw at the side
nearest the engine.
► Push the wing screw into the handle support
as far as stop and then screw it down – but do
not finally tighten yet.
► Line up the handlebar at a right angle to the
drive tube – check distance A again.
► Tighten down the wing screw firmly.
8
5.1.3
A
1
► Take out the screw (9) – the nut (10) remains
in the control handle (11).
► Push the control handle onto the handlebar (7)
until the holes (13) line up – the throttle trig‐
ger (12) must point towards the gearbox.
► Insert the screw (9) and tighten it down firmly.
5 Mounting the Bike Handle
Mounting the Control Handle
0458-516-0121-B