Transferring A Finalized Configuration - Siemens SIMATIC Ident RF1000 Configuration Manual

Creating and transferring a configuration

5.4 Transferring a finalized configuration

Figure 5-6
5.4 Transferring a finalized configuration
The following options are available to you for transferring a finalized configuration to a
reader:
• Transfer configuration via configuration card and demo application.
• Transfer configuration via computer and Uploader.
Transferring finalized configuration via configuration card and demo application
Requirements
• The demo application "RF1000R.exe" ("AccessControlDemo.exe") has been installed on
your computer.
• An RF1000 reader that you can connect to your computer.
• A configuration card with a finalized "*.balcfg" file.
Procedure
Follow these steps to transfer your configuration to a reader via configuration card:
1. Open the demo application by double-clicking the "AccessControlDemo.exe" file.
2. Select the "Configcard" check box.
3. Hold the configuration card to the reader that you want to configure.
Result: The configuration file is transferred to the reader. While the card is being processed,
the LED on the reader lights up in yellow and a continuous audio signal is generated,
followed by a pause of several seconds and the signal indicating the result of the transfer. If
the transfer was successful, the LED on the reader turns green after the pause and a single
audio signal is generated at the same time. If the transfer failed, the LED on the reader turns
red after the pause and several short audio signals are generated at the same time.
28
Example of configuration card labeling
Configuration Manual, 07/2021, C79000-G8976-C647-01
SIMATIC RF1000