Troubleshooting - Stanley DUBUIS BPP060F User Manual

The tool won't crimp when I press the trigger.
The InteLED flashes red when I activate the tool.
At the end of the crimp cycle, Inteled flashes red and then
flashes green for good crimp and then InteLED lights up
white.
Before the automatic switch off of the tool, InteLED flashes
white during 10 seconds, red during 1 second and the
tool switches off.
The tool repeatedly give me bad crimps / The InteLED
flashes red after every crimp.
The tool is leaking hydraulic oil.
The tool is not saving data or will not connect to DUBUIS
Crimp software.

TROUBLESHOOTING

Problem
Ensure the battery is charged.
Disengage the trigger lock.
The maintenance interval is about to elapse.
Have the tool serviced as soon as possible.
The maintenance is achieved.
Have the tool serviced
immediately.
Ensure the battery is fully charged.
Ensure the dies are inserted properly into the crimping
head.
If problem persists, have the tool serviced as soon as
possible.
Have the tool serviced immediately.
Have the tool serviced as soon as possible.
Solution
BPP060F User Manual ◄ 17