Loading Sheet Media - Roland SJ-645EX User Manual

2-2 Loading Media

Loading Sheet Media

Before attempting to load sheet media, check the following points.
Front View
Line up the right edge of the media with the guide line, and align the front edge with the location shown in the figure.
If the front edge of the media is cut at an angle, load the media so that its edge is lined up straight with the guide line.
Be sure to line up the right-hand edge of the media with the guide line.
If the media is not positioned correctly when you press the [SETUP] key, the message "SHEET SET ERROR SET AGAIN"
appears on the display.
Rear View
Remove the left-hand media flange at the back of the unit. Move the right-hand media flange at the back of the unit to a
position where it does not touch the loaded media. Drape the pulled-out media at the back between the machine and the
media guide.
Chapter 2: Basic Operation
40
Media Align here.
Media flange
Media
Guide line
Media flange
Media guide