1-3 Assembling and Installing
Step 4: Remove the Protective Media
The protective media shown below is attached to this machine when it is shipped from the factory. When you have
finished installing the machine, remove all protective media.
Front
5) Peel off the tape.
Rear
Chapter 1: Getting Started
26
Packing
1) Remove these packings.
6) Remove the retainer (1).
If the screw for the retainer is difficult to loosen, use a screw-
driver to remove it.
8) Attach the retainers you re-
moved in step 6) and 7).
Packing
4) Peel off the tape, and
remove the packing.
(Pull straight back to-
ward you to extract.)
7) Remove the retainer (2).
2) Peel off the tape.
3) Peel off the tapes,
and remove the
packings.
Retainer (2)
Retainer (1)