Holes Used For Mounting Boards And Wood Lathe To Leg Set; Mounting Left Side Table Top - RIDGID WL1200LS1 Operator's Manual

Assembly (continued)

Holes Used for Mounting Boards and Wood Lathe to Leg Set

G H
J
H
G
F
J
G
C
E
C
E
A - Board/Side Support
B - Board/Side Support
C - Plate Support/Board/End Support
D - Board/End Support
E - Headstock/Plate Support/Board

Mounting Left Side Table Top

1. Find the following:
1 Particle Board Table Top
1 Plate Support (Steel)
2. From the loose parts package find the
following:
4 M6 x 1.0-45 Carriage Bolts
4 M6 x 1.0 Hex Head Nuts
4 6.5 x 19 x 1.6 Flat Washers
4 6mm Lockwashers
3. Position the table top on the left side of
the assembled legset as shown
4. Front Side Stiffeners
Face the front of the legset and count
over from the left one slot and one hole.
Place a carriage bolt through the table
top (hole A) and the side stiffener. Fas-
ten in place with a washer, lockwasher
and nut. Finger tighten only.
5. Rear Side Stiffener
Face the rear of the legset and count
over from the right two holes. Place a
carriage bolt through the table top (hole
A) and the side stiffener. Fasten in
place with a washer, lockwasher and
nut. Finger tighten only.
6. Locate the two holes marked C in the
steel plate support. Place bolts;
- through these holes
H
H
B
A
B
A
F - Bracket Plate/Plate Support/Board/
Side Support
G - Belt Guard/Plate Support
H - Motor/Plate Support
J - Cord Clamps/Plate Support
K - Rear Foot/Board
- through the two holes marked C on
the table top
- and through the holes marked C in
the End Stiffener. Place a washer,
lockwasher and nut on these bolts.
Finger tighten only.
Plate Support (Steel)
Flat Washer
6.5 x 19 x 1.6
12
D
D
Particle Board Table Top
Carriage Bolt
M6 x 1.0-45
Lockwasher
6mm
K
Nut Hex
M6 x 1.0